Step-by-Step Guide: Installing Your Intelligent Controller with Ease

Preparation Before Installation

1. Verify Pump and Pipeline Readiness

• Ensure the pump is in working condition and the water source is sufficient.
• Check the pipeline for blockages or debris to avoid interference with the controller's performance.

2. Check Accessories and Power Supply

• Use a compatible three-core round cable (7-8mm diameter, 1.5mm² cross-section).
• Confirm that the power supply meets the controller’s requirements (AC 100-240V).

3. Gather Necessary Tools

• Tools like screwdrivers and wire strippers.
• Sealing materials such as Teflon tape to prevent water leakage.

Installation Steps

Step 1: Mounting the Controller

1. Choose the Installation Location
   • Place the intelligent controller between the pump outlet and the pipeline.
   • Flexible Orientation: Thanks to the electronic pressure sensor, the controller can be installed horizontally or vertically without affecting performance.
2. Prepare the Pipeline
   • Clear any glue or foreign substances to avoid malfunction.
3. Secure the Controller
   • Use the 1-inch interface to connect the controller to the pipeline. Ensure a tight seal to prevent leaks.

Step 2: Wiring the Controller